CAR OBD CODES

P2181 OBD Code Definition:
P2181 Cooling System Performance
P2181 OBD Code Description:

• Malfunction Indicator Light (MIL) ON
• Reduced Heater Output – Cold toes
• Incorrect Temperature Gauge Readings
• Increased Emissions

• Faulty Coolant Sensor
• Faulty Coolant Thermostat
• Faulty Wiring, Connections

Note: This fault code sets when engine coolant temperature mapping is lower and out of expected range based on operating conditions of the engine.

• For example: Engine warms up, thermostat opens and stays open, coolant temperature drops below normal operating range. The ECM knows the coolant temperature should stay within 80.0…110.0 °C typically after warm up. Thus a drop in coolant temperature below normal operating temperature is not possible without a Malfunction in Cooling System.

• Check G62 – Engine Coolant Temperature Sender
  • Inspect wiring for G62 (Coolant Migration, damage, corrosion, etc)

• Check (if applicable) G83 – Radiator Outlet, Coolant Temperature Sender
  • Inspect wiring for G83 (Coolant Migration, damage, corrosion, etc)

• Check Coolant Thermostat
  • Use Graph function in VCDS, Measuring Value Blocks – MVB
  • Start Engine cold, graph Coolant Temperature Sender (G62) Typically MVB Group-001
  • Hold RPM around 1,500rpm and watch coolant temp increase in Graph until thermostat opens, indicated by a slight drop in coolant temp
  • If coolant temp drops below minimum operating temperature (80°C) or never reaches operating temperature, (verified by external thermometer) suspect failed thermostat

• Vehicles with both G62-Engine Outlet, Coolant Temperature Sensor and G83-Radiator Outlet, Coolant Temperature Sensor
  • Use Measuring Value Block group MVB-130 instead on MVB-001
  • G62 should increase in Temperature before G83 increase when engine coolant is cold
  • G83 will increase when the thermostat opens and after G62 reaches operating temperature (80°C)
  • If G62 and G83 both increase while engine warms up, suspect failed thermostat

• Check the stored Freeze frame data with this fault code. Freeze frame information will be found in the fault code description (if the module supports it) or in Generic OBD-II if the vehicle complies with those regulations.
  • Freeze frame data stored at -40*C is generally an indication of a faulty ECT or wiring.
  • Freeze frame data stored at +140*C is generally an indication of a faulty ECT or wiring.
  • Freeze frame data stored with in the 68*C ~ 80*C range is an indication that the vehicle was close to, but not within, the cooling systems normal operation range. The Thermostat itself or Cooling system components may be at fault.